KitchenAid 24'' 6-Cycle/5-Option Dishwasher, Architect® Series II Installation Guide

 

Using 2 or more people, stand the dishwasher up.
NOTE: Do not install kick plate until instructed to do so.

For custom panel installation, refer to the Custom Panel 
Installation Instruction Sheet (Part Number W10750117A). 
Complete custom panel installation before proceeding to the 
“Choose Attachment Option” section.

IMPORTANT: The dishwasher must be secured to the cabinet as 
one of the final steps. Prepare the dishwasher for this by attaching 
the two brackets found in the parts bag to the dishwasher. 
For countertops that are wood, laminate, or another similar 
surface, use Option A. 
For countertops that are marble, granite, or another hard surface, 
use Option B. 

Remove the brackets from the package and insert into the open 
slots on the left-hand and right-hand top of the dishwasher collar, 
as shown.

Using a pair of pliers, bend the tab down to secure the bracket in 
place. Repeat this step for the other side.
NOTE: Do not attach the dishwasher. This will be done later.

NOTE: Remove the brackets from the parts package.

Break off the end of the bracket along the scored line. 
With another person holding the rear of the dishwasher to keep it 
from tipping, open dishwasher door and place towel over pump 
assembly and spray arm of dishwasher. This will keep screws 
from falling into pump area when you are securing dishwasher to 
cabinet.

Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after dishwasher is 
installed.