KitchenAid 29.5 cu. ft 48-Inch Width Built-In Side by Side Refrigerator Dimensional Illustrations
PRODUCT MODEL NUMBERS
Side by Side Built-In Refrigerator
KBSD502E
KBSD508E
KBSN508E
KSSC42FT
KSSC42QV
KSSC48FT
KSSC48QV
KSSO42FT
KSSO48FT
Electrical: A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a switch. Do not use an extension
cord.
Water Supply: A cold water supply with water pressure between 30 and 120 psi (207
and 827 kPa) is required to operate the water dispenser and ice maker. If you have
questions about your water pressure, call a licensed, qualified plumber.
Reverse Osmosis Water Supply:
IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi
(207 and 827 kPa).
is required. It is recommended that a separate circuit serving only your refrigerator be
provided. Use an outlet that cannot be turned off by a switch. Do not use an extension
cord.
Water Supply: A cold water supply with water pressure between 30 and 120 psi (207
and 827 kPa) is required to operate the water dispenser and ice maker. If you have
questions about your water pressure, call a licensed, qualified plumber.
Reverse Osmosis Water Supply:
IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi
(207 and 827 kPa).
OPENING DIMENSIONS
To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum
above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one is not
available, then the refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to 90"
(203 cm to 229 cm) above the floor. See “Install Anti-Tip Boards” for more information.
NOTE: A clearance of Z\x" (1.3 cm) above the top grille must be maintained in order for
the top grille to be removed.
above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one is not
available, then the refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to 90"
(203 cm to 229 cm) above the floor. See “Install Anti-Tip Boards” for more information.
NOTE: A clearance of Z\x" (1.3 cm) above the top grille must be maintained in order for
the top grille to be removed.
IMPORTANT:
n
n
It is recommended that you do not install the refrigerator near an oven,
radiator, or other heat source.
radiator, or other heat source.
n
Do not install in a location where the temperature will fall below
55°F (13°C).
55°F (13°C).
n
Floor must support the refrigerator weight, more than 600 lbs (272 kg),
door panels and contents of the refrigerator.
door panels and contents of the refrigerator.
6"
(15.2 cm)
24"
(60.96 cm) min.
1"
(2.54 cm)
77"
(196 cm)
6"
(15.2 cm)
6"
(15.2 cm)
A
Width
(see chart following)
B
Dimension
84" (213.4 cm)
to bottom of solid soffit
Model
Width A
(as shown above)
Width A for
Overlay Models
(as shown above)
Dimension B
(as shown above)
36
35Z\x" to 35C\v"
(90.2 cm to 90.8 cm)
35C\v" to 36"
(90.8 cm to 91.4 cm)
4" (10.2 cm)
42
41Z\x" to 41C\v"
(105.4 cm to 106.1 cm)
41C\v" to 42"
(106.1 cm to 106.7 cm)
7Z\x" (19.1 cm)
48
47Z\x" to 47C\v"
(120.7 cm to 121.3 cm)
47C\v" to 48"
(121.3 cm to 121.9 cm)
13Z\x" (34.3 cm)
NOTE: Flooring under refrigerator must be at same level as the room. Face of cabinetry must be plumb.
PRODUCT DIMENSIONS
n
The depth from the front of the top grille to the back of the refrigerator
cabinet is 25C\₈" (64.5 cm).
cabinet is 25C\₈" (64.5 cm).
n
The power cord is 84" (213 cm) long.
n
The water line attached to the back of the refrigerator
is 5 ft (1.5 m) long.
is 5 ft (1.5 m) long.
n
Height dimensions are shown with leveling legs extended Z\₈" (3 mm)
below the rollers.
below the rollers.
25
³⁄₈
"
(64.5 cm)
23
¹⁄₂
"
(59.7 cm)
84" (213.4 cm)
Power Cord
*83
³⁄₈
"
(211.8 cm)
*3
¹⁄₂
" (8.9 cm)
*When leveling legs are fully extended to 1Z\v" (3.2 cm) below rollers, add
1Z\₈" (2.9 cm) to the height dimensions.
1Z\₈" (2.9 cm) to the height dimensions.
SIDE VIEW
TOP VIEW
25
C\₈
"
(64.5 cm)
A
Model
Width A
36
35" (88.9 cm)
42
41" (104.1 cm)
48
47" (119.4 cm )
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10681447A
4/15