Zanussi ZHP615X Instruction Manual

•  The  hood  support  surface  must  be  135  mm

above the bottom surface of the wall units.

•  Drill the support with a ø 4,5 mm drill bit, using

the drilling template provided.

•  Cut a hole ø 125 mm in size on the support sur-

face, using the drilling template provided.

•  Fix using the 4 screws

12a (4,2 x 44,4) provid-

ed.

•  The hood can be installed either directly on the

bottom  surface  of  the  wall  units  using  snap-on

side supports.

•  Cut a fitted opening in the bottom surface of the

wall unit, as shown.

•  Insert the hood until the side supports snap into

place.

•  Lock in position by tightening the screws

Vf from

underneath the hood.

•  The space between the edge of the hood and the

rear wall can be closed by applying the element

20 provided, using the screws supplied for this

purpose.

���

��

�

���

���