Zanussi ZHP615WM Instruction Manual

• The hood support surface must be 135 mm

above the bottom surface of the wall units.

• Drill the support with a ø 4,5 mm drill bit, using

the drilling template provided.

• Cut a hole  ø 125 mm in size on the support

surface, using the drilling template provided.

• Fix using the 4 screws 12a (4,2 x 44,4) provided.

• The hood can be installed either directly on the

bottom surface of the wall units (min. 650 mm
above the hob) using snap-on side supports.

• Cut a fitted opening in the bottom surface of

the wall unit, as shown.

• Insert the hood until the side supports snap into

place.

• Lock in position by tightening the screws Vf

from underneath the hood.

12a

135

125

125