Zanussi ZBT23420SA User Manual

Water flows on the floor.

The melting water outlet is

not connected to the evapo-

rative tray above the com-

pressor.

Attach the melting water outlet to

the evaporative tray.

The temperature in the appli-

ance is too low/too high.

The temperature regulator is

not set correctly.

Set a higher/lower temperature.

The door is not closed cor-

rectly.

Refer to "Closing the door".

The food products' tempera-

ture is too high.

Let the food products tempera-

ture decrease to room tempera-

ture before storage.

Many food products are stor-

ed at the same time.

Store less food products at the

same time.

The thickness of the frost is

greater than 4-5 mm.

Defrost the appliance.

The door has been opened

often.

Open the door only if necessary.

If the advice does not lead to the

desired result, contact the nearest

Authorised Service Centre.

REPLACING THE LAMP
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new lamp of the

same power and specifically designed for

household appliances (the maximum power is

shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.
Make sure that the light comes on.

CLOSING THE DOOR
1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective door

gaskets. Contact the Authorised Service

Centre.

WARNING! Refer to Safety chapters.

Refer to the assembly instructions for

the installation.

To ensure best performance, install the appliance

well away from sources of heat such as radiators,