Zanussi ZBF11421SA User Manual

Page of 36
Problem
Possible cause
Solution
Food products are not wrapped
properly.
Wrap the food products better.
Temperature is set incorrectly.
Refer to "Operation" chapter.
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
This is normal, no error has oc-
curred.
The compressor starts after a pe-
riod of time.
Temperature cannot be set.
The QuickFreeze or QuickChill
function is switched on.
Switch off QuickFreeze or Quick-
Chill manually, or wait until the
function resets automatically to
set the temperature. Refer to
"QuickFreeze or QuickChill func-
tion".
The temperature in the appliance
is too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly.
Refer to "Closing the door".
The food products' temperature
is too high.
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Many food products are stored at
the same time.
Store less food products at the
same time.
The thickness of the frost is
greater than 4-5 mm.
Defrost the appliance.
The door has been opened often. Open the door only if necessary.
The QuickFreeze function is
switched on.
Refer to "QuickFreeze function".
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
Installation
WARNING!
Refer to Safety chapters.
Location
Refer to the assembly instructions
for the installation.
www.zanussi.com
21