Zanussi ZKC44500XA User Manual

END

To set when the appliance must deactivate. Use only when an

oven function is set. You can use Duration and End at the

same time (time delay), if the appliance is to be activate and

deactivate automatically later.

Press   again and again to switch

between the clock functions.

To confirm the settings of the clock
functions, press   or wait 5 seconds

for an automatic confirmation.

SETTING THE DURATION OR END
1. Set an oven function.
2. Press   again and again until the display

shows 

 or 

.

 or 

 flashes in the display.

3. Press   or   to the set the values and press

 to confirm.

For Duration 

 first you set the minutes and

then the hours, for End   first you set the

hours and then the minutes.

An acoustic signal sounds for 2 minutes after the
time ends. 

 or 

 symbol and time setting flash

in the display. The oven stops.

4. Press any button to stop the acoustic signal.

5. Turn the knob for the oven functions to the off

position.

If you press   when you set the
hours for DURATION 

, the

appliance goes to setting of the END

 function.

1. Press   again and again until   and "00"

flash in the display.

2. Press   or   to set the MINUTE MINDER.

First you set the seconds, then the minutes and

then the hours.

At first, the time is calculated in minutes and

seconds. When the time you set is longer than
60 minutes, the symbol 

 comes on in the

display.

The appliance now calculates the time in hours and

minutes.

3. The MINUTE MINDER starts automatically after

five seconds.

After 90% of the set time, an acoustic signal

sounds.

4. When the set time ends, an acoustic signal

sounds for two minutes. "00:00" and   flash in

the display. Press any button to stop the

acoustic signal.

If you set the MINUTE MINDER when
the DURATION 

 or END 

function operates, the symbol 

comes on in the display.

COUNT UP TIMER
Use the Count Up Timer to monitor how long the

oven operates. It is on immediately when the oven

starts to heat.
To reset the Count Up Timer, press and hold 
and  . The timer starts to count up again.

The Count Up Timer cannot be used
with the functions: Duration 

, End

.

WARNING! Refer to Safety chapters.

INSERTING THE ACCESSORIES
Wire shelf: