Zanussi ZCV66AEWC User Manual

Use small feet on the bottom of appliance to set the

appliance top surface level with other surfaces.

ANTI-TILT PROTECTION
Adjust the appliance to the correct height and put it

in the correct area before you attach the anti-tilt

protection.

CAUTION! Install the anti-tilt

protection to prevent the appliance

from falling under incorrect loads. The

anti-tilt protection only works when the

appliance is put in a correct area.

The anti-tilt protection has two parts (A + B). You

can find the anti-tilt protection (B) on the right or

left side of the rear wall of the appliance.

1. Install the anti-tilt protection (A) on the wall.

Make sure that the wall is made of a solid

material. If not, you need to make the wall

sufficiently strong to hold the weight.

Make sure that the surface behind the

appliance is smooth.

2. Put the appliance in the middle of the space

between the cupboards.

If the space is larger than the width of the

appliance, you must adjust the side

measurement.

3. Install the anti-tilt protection (A) approximately

77 mm below the top surface of the appliance

and 50 mm from the left or right side of the

appliance into the circular hole on the bracket.

Screw it into the wall.

50 mm

77 mm

4. Check that the anti-tilt protection (A) fits

minimum 20 mm into the hole in the rear wall of

the appliance (B) when you push the appliance.

WARNING! The manufacturer is not

responsible if you do not follow the

safety precautions from Safety

chapters.

This appliance is supplied without a main plug or a

main cable.

• The recommended cross-section area is six

square millimetres (6 mm²).

• When you refit the mains terminal cover, make

sure that the lower tabs are located inside the

bottom edge of the aperture, before you fix the

two screws into the top edge of the mains

terminal cover.

• Make sure that the cover is securely fastened.

To open the cover of terminal board

obey the procedure in opposite

sequence.

Do not remove blanking plates.

Make sure that the links are fitted as shown.