Zanussi ZRB23200XA User Manual

3

 

•  Do not damage the refrigerant circuit
•  Do not use electrical appliances inside the food storage com-

partments of the appliance, unless they are of the type recom-

mended by the manufacturer

•  Do not use water spray and steam to clean the appliance
•  Clean the appliance with a moist soft cloth. Only use neutral 

detergents. Do not use abrasive products, abrasive cleaning 

pads, solvents or metal objects

•  Do not store explosive substances such as aerosol cans with a 

flammable propellant in this appliance

•  If the supply cord is damaged, it must be replaced by the man-

ufacturer, its service agent or similarly qualified persons in order 

to avoid a hazard

Warning! Only a qualified person must 

install this appliance

•  Remove all the packaging
•  Do not install or use a damaged appli-

ance

•  Obey the installation instruction sup-

plied with the appliance

•  Always be careful when you move the 

appliance because it is heavy. Always 

wear safety gloves

•  Make sure the air can circulate around 

the appliance

•  Wait at least 4 hours before connecting 

the appliance to the power supply. This 

is to allow the oil to flow back in the 

compressor

•  Do not install the appliance close to 

radiators or cookers, oven or hobs

•  The rear of the appliance must stand 

against the wall

•  Do not install the appliance where there 

is direct sunlight

•  Do not install this appliance in areas 

that are too humid or too cold, such as 

the construction appendices, garages 

or wine cellars

•  When you move the appliance, lift it by 

the front edge to avoid scratching the 

floor

Warning! Risk of fire and electrical 

shock.

•  The appliance must be earthed
•  All electrical connections should be 

made by a qualified electrician

•  Make sure that the electrical informa-

tion on the rating plate agrees with 

the power supply. If not, contact an 

electrician

•  Always use a correctly installed shock-

proof socket

•  Do not use multi-plug adapters and 

extension cables

•  Make sure not to cause damage to the 

electrical components (e.g. mains plug, 

mains cable, compressor). Contact the 

Service or an electrician to change the 

electrical components

•  The mains cable must stay below the 

level of the mains plug

•  Connect the mains plug to the mains 

socket only at the end of the installation. 

Make sure that there is access to the 

mains plug after the installation