Zanussi ZDF21001NA User Manual

Page of 20
Problem
Possible cause and solution
Traces of rust on cutlery.
• There is too much salt in the water used for washing. Refer to 
"The water softener".
• Silver and stainless steel cutlery were placed together. Avoid
to put silver and stainless steel items close together.
There are residues of detergent
in the dispenser at the end of the
programme.
• The detergent tablet got stuck in the dispenser and therefore
was not completely washed away by water.
• Water cannot wash away the detergent from the dispenser.
Make sure that the spray arm is not blocked or clogged.
• Make sure that items in the baskets do not impede the lid of
the detergent dispenser from opening.
Odours inside the appliance.
• Refer to "Internal cleaning".
Limescale deposits on the table-
ware, on the tub and on the in-
side of the door.
• Refer to "The water softener".
Dull, discoloured or chipped ta-
bleware.
• Make sure that only dishwasher-safe items are washed in the
appliance.
• Load and unload the basket carefully. Refer to basket loading
leaflet.
• Place delicate items in the upper basket.
Refer to "Before first use""Daily
use" or "Hints and tips" for other
possible causes.
TECHNICAL INFORMATION
Dimensions
Width / height / depth (mm)
600 / 850 / 625
Electrical connection 
1)
Voltage (V)
220 - 240
Frequency (Hz)
50
Water supply pressure
Min. / max. bar (MPa)
0.5 (0.05) / 8 (0.8)
Water supply
Cold water or hot water 
2)
max 60 °C
Capacity
Place settings
13
Power consumption
Left-on mode (W)
5.0
Power consumption
Off-mode (W)
0.50
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
16