Ariston MARCO POLO Gi7S 11 L FFI серебристый User Manual

7

Ⅳ

●Press the power button on the control panel to turn the LCD on. The screen flashes to show 
42℃ for 3 seconds (Default temperature setting). 

●Open the hot-water faucet, the burner inflames automatically and hot water flows out. (For the first 
 running, open and close the hot-water faucet repeatedly till water heater inflames, to discharge air 
 residue in the gas pipe.)

●The faucet is recommended to be turned to large extent. Otherwise ignition may be unavailable, or
it may be flameout during the cold-water mixing process.
●The water heater adopts new safe and gas-saving technology. Gas will be cut off automatically after
water heater works for 45±3min without interruption. Then burner is extinguished. If more service is 
required, just close the faucet for several seconds and restart, re-ignition will be available then. 

8

●If both control panel and wireless remote controller are connected with water heater, please confirm if

priority indication lamp is on.

Adjustment by 

control panel

Adjustment by 

wireless remote

controller

If priority indication on 

the control panel turns 

bright 

If priority indication on 

the control panel does 

not turn bright 

If priority indication on 

the control panel turns 

flashing 

If priority indication on 

the wireless remote

 controller turns bright 

If priority indication on 

the wireless remote

controller does not 

If priority indication on 

the wireless remote

controller flashes

●Control panel is given priority. It’s allowed to 

start/stop water heater, adjust the water 

temperature, set water flux and etc.

●Remote controller is given priority. Therefore 

temperature adjustment is not available for the 

control panel. User can only read the 

temperature, however, on/off button still works.

●Start/stop the water heater with on/off button 

to get the priority. Then priority indication turns 

bright.

●Remote controller is given priority. Water 

temperature adjustment is locked at this time,

because hot water is being used. User can only 

read the temperature, however, water flux 

setting still works. 

●In such case it is impossible for the control 

panel to get priority. On/off button is invalid.

●Remote controller is given priority. It’s allowed

to start/stop water heater, adjust the water 

temperature, set water flux and etc.

●If hot water is not working, tap the priority

button then the priority icon disappears. 

Meanwhile control panel is given priority.

●Control panel or other remote controller is 

given priority. Adjustment buttons are locked,

user can only read the temperature. And other

function buttons are invalid, too. On/off button

can only start or stop remote controller but not

water heater.

●Tap the priority button to get priority. Start 

setting and/or adjustment till priority icon

shows up.

●Control panel or other remote controller (if 

more than one remote controllers are mounted) 

is given priority. Adjustment buttons are locked

because hot water is working. At this time, user 

can only read the temperature. And other

functions are unavailable, too. On/off button

can only start or stop remote controller but not

water heater.

●In such case it is impossible to get priority.

●Temperature setting range of water heater is 35-70℃. When temperature is within 35-48℃,tap the
temperature setting button to increase or decrease temperature, it actually switches by 1℃/tap.
Right after the completion of temperature setting, temperature icon flashes for 3 sec and then stays still. 
If temperature is within 50-70℃, tap the temperature setting button to increase or decrease the 
temperature by 5℃/tap. And when temperature setting completes, temperature icon flashes for 10 sec 
and then stays still.

turn bright