Cisco Cisco ACE Application Control Engine Module White Paper
© 2011 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 17 of 40
Step 7. Verify the FT group transition using the show ft group brief command. All the FT groups should show a
“My State” as active and the “Sync Status” as “Successful”:
ACE-sec/Admin# show ft group brief
FT Group ID: 1 My State:
FSM_FT_STATE_ACTIVE
Peer
State:FSM_FT_STATE_STANDBY_WARM
Context Name: Admin Context Id: 0 Running Cfg Sync
Status: Successful
FT Group ID: 2 My State:
FSM_FT_STATE_ACTIVE
Peer
State:FSM_FT_STATE_STANDBY_WARM
Context Name: web-apps Context Id: 3 Running Cfg Sync
Status: Successful
ACE-sec/Admin#
Migrate Primary ACE10 or ACE20 to ACE30
Step 1. Power down the primary ACE10 or ACE20 from the primary Cisco Catalyst Supervisor Engine720:
cat6k-pri#show module services
Module
Model Services
---------- ----------------- --------------------
1 ACE10/20-MOD-K9 ACE-16G-LIC ACE-VIRT-250 ACE-SSL-15K-K9
cat6k-pri#conf t
Enter configuration commands, one per line. End with CNTL/Z.
cat6k-pri(config)#no power enable
module 1
%Power admin state updated
Step 2. Physically replace the primary Cisco ACE10 or ACE20 module with the Cisco ACE30a module:
Step 3. Power on ACE30a. The ACE30a will boot as standby.
cat6k-pri(config)#power enable
module 1
%Power admin state updated
cat6k-pri(config)#exit