Cisco Cisco Content Security Management Appliance M1070 User Guide
Chapter 11 Common Administrative Tasks
11-40
Cisco IronPort AsyncOS 7.2.0 for Security Management User Guide
OL-21768-01
In this case, you must re-enable services for ESA 1-3 and WSA 1. For more
information on enabling services, see
information on enabling services, see
.
Step 6
Test to see that each appliance is enabled and working by establishing a
connection to the appliances and testing the connections.
connection to the appliances and testing the connections.
At this point you have all data directed to SMA 2 as shown in
Figure 11-12
.
Figure 11-12
Disaster Recovery: Part 2—New Security Management
Appliance
Appliance
Note
If you have periodically saved your configuration using the
saveconfig
command, you can load this saved configuration file to the new Security
Management appliance (SMA 2 in this example) by using the
Management appliance (SMA 2 in this example) by using the
loadconfig
command and then setting the new IP address described in Step 2. The
configuration file does not include all information needed to make the SMA 2
function. You will still need to add all of the appliances to the new Security
Management appliance. From there, you must establish a connection to each
appliance and test the connections.
configuration file does not include all information needed to make the SMA 2
function. You will still need to add all of the appliances to the new Security
Management appliance. From there, you must establish a connection to each
appliance and test the connections.
SMA 2
ESA 2
ESA 1
WSA 1
ESA 3