Philips wet and dry electric razor 1260X/40 1260X/40 User Manual
Product codes
1260X/40
ENGLISH
C
12
Insert the notch of the shaving unit into
the slot in the top of the razor (
1). Then
press the shaving unit down (2) to attach it
to the razor. You will hear a ‘click’.
Cleaning the Trimmer
Clean the trimmer after each use.
1
Press the trimmer slide forward to slide
out the trimmer.
C
2
Rinse the trimmer under hot water. BUT
BE CAREFUL TO TEST WATER FIRST SO
AS NOT TO BURN OR SCALD HANDS.
3
Allow trimmer to air dry.
Tip: For optional trimmer performance, lubricate
the trimmer teeth with one drop of mineral oil
every 6 months.
Cleaning the Jet Clean Canister
(1280XCC and 1250XCC)
For optimal performance of the Jet Clean
System, it is recommended that you empty the
cleaning solution canister and thoroughly rinse
the canister clean every 2 weeks.
1
Place the Jet Clean System on a flat, level
surface.
36
ENGLISH
C
2
Simultaneously press the buttons located
on both sides of the Jet Clean System
(1) and lift the appliance off the Jet Clean
canister (2).
Always remove appliance from canister by lifting
straight up. Do not tilt Jet Clean System.
C
3
Discard any remaining cleaning solution in
the canister.
The cleaning solution can be safely poured down
the sink as there are no harmful ingredients.
C
4
Simply rinse the canister with warm water.
Wipe the canister with a towel or tissue
to remove excess water.
C
5
Pour the Jet Clean Solution into the
canister up to a level between the two
lines located inside the canister.
C
6
Carefully lower the Jet Clean System
over the canister making sure the release
buttons snap back into position.
37
C
F
2
1