Cisco Cisco Prime Optical 10.6 Developer's Guide
Cisco Prime Optical 10.6 GateWay/CORBA Programmer Reference Guide
377
• PMLocation_T pmLocation
– Prime Optical supports PML_NEAR_END_RX and PML_FAR_END_RX.
• PMThresholdType_T thresholdType
– Prime Optical supports only TWM_HIGH.
• boolean triggerFlag
– Not supported.
• float value
– Supported. The NE accepts only integer values. Therefore, Prime Optical rounds off floating
point values to the biggest lower integer. The maximum value supported is 9999999.
• string unit
– Not supported.
Throws
Compliance
TMF-defined.
TMF-defined.
3.13.4 getTCATPParameter
Synopsis
Description
The purpose of this operation is to retrieve the values of 15-minute or 24-hour TCA/alarm thresholds on a
TP/layer rate measurement point. The operation is best-effort. Results are returned in the out parameter of
this operation. The operation can be applied to either a PTP or CTP. The NMS requests the TCA
parameters for the particular TP and granularity specified.
A set of TCA/alarm thresholds is supported for Optical, OTN, SONET and SDH layer rates.
Parameters
Name
The purpose of this operation is to retrieve the values of 15-minute or 24-hour TCA/alarm thresholds on a
TP/layer rate measurement point. The operation is best-effort. Results are returned in the out parameter of
this operation. The operation can be applied to either a PTP or CTP. The NMS requests the TCA
parameters for the particular TP and granularity specified.
A set of TCA/alarm thresholds is supported for Optical, OTN, SONET and SDH layer rates.
Parameters
Name
Type
Input/Output Description
tpName
globaldefs::NamingAttributes_T
In
Identification of the TP for
which to retrieve the values of
the TCA parameters.
which to retrieve the values of
the TCA parameters.
layerRate
transmissionParameters::LayerRate_T In
Layer rate for which to retrieve
the values of the TCA
parameters.
the values of the TCA
parameters.
granularity
Granularity_T
In
Granularity for which to retrieve
the TCA parameters.
the TCA parameters.