Cisco Cisco Prime Optical 10.6 Developer's Guide

Cisco Prime Optical 10.6 GateWay/CORBA Programmer Reference Guide 

 

 

380

 

pmParameters PMParameterNameList_

T 

In 

This parameter specifies which PM parameters 
within the scope of the pmTPSelectList shall be 
contained in the file. An empty list means to store all 
supported parameters. The returned parameters are 
best effort; that is, among the parameters specified, 
only the subset of supported parameters will be 
stored. 

startTime 

globaldefs::Time_T 

In 

Specifies the start of the time window for collection 
(included). 

endTime 

globaldefs::Time_T 

In 

Specifies the end of the time window for collection 
(included). 

Prime Optical support for PMTPSelect_T structure for this method is as follows: 

•  globaldefs::NamingAttributes_T name 

–  The name of the object to which this selection applies. Prime Optical supports only 

ManagedElement, PTP, or CTP name in this field. Note that ManagedElement must be in 
Prime Optical’s management domain. For example, if you change the name of the ME but 
you pass the old name to this call, no data is written to the file. 

•  transmissionParameters::LayerRateList_T layerRateList 

–  For a list of supported layer rates, see 

.  

•  PMLocationList_T pMLocationList 

–  Prime Optical supports only PML_NEAR_END_RX and PML_FAR_END_RX. 

•  GranularityList_T granularityList 

–  Prime Optical supports 15-minute (15min) and 24-hour (24h) PM data. If this list is empty, 

data for all granularities is reported. 

Prime Optical supports the PM parameter values listed in 

, and 

. 

Throws 

Compliance 
Prime Optical-defined. 

Synopsis