Cisco DNCS System Release 2.8.1 3.8.1 4.3.1 User Guide

MPEG Program
Number

The MPEG program being fed into the transport stream.

This number must match the program number of the MPEG source as defined by
your content provider.

Channel Center
Frequency

The channel frequency of the channel you will use to send data from this
modulator to the hubs on your system. 

You can enter a value in 6 MHz increments from 91 to 867.

Click for a 

.

Modulation Type

The type of modulation this modulator uses.

Example: If this modulator uses ITU J.83 Annex B modulation, select ITU J.83
Annex B (6 MHz).

Modulation

The modulation method this modulator uses.

Example: If this modulator uses 256 QAM, select 256-QAM.

11.

Click Save. The system closes the Set Up Non-SA Digital Source Definition window and the Source

Definition List window updates to include the new non  SA source.

12.

Repeat this procedure from step 5 for each QAM modulator from another manufacturer you are using

to deliver broadcast services.

13.

From the Source Definition List window, select File > Close.

14.

From the Source List window, select File > Close.

15.

Now that you have added source definitions for each QAM modulator from another manufacturer that

you are using to deliver broadcast services, reboot the SI manager process to have these changes take
effect. Go to 

.