Samsung AR12FSFPKGMN User Manual

Cutting or extending the pipe

Outer Diameter

Torque (kgf•cm)

ø6.35 mm

140~170

ø9.52 mm

250~280

ø12.70 mm

380~420

ø15.88 mm

440~480

ø19.05 mm

990~1210

ø22.23 mm

990~1210

Indoor outlet pipe

Connecting pipe

Flare nut

Wall

Indoor unit

Drain hose

The drain hose must NOT

slant upwards.

The end of the drain hose must NOT

be placed under water.

The drain hose must not

be bent.

Keep a clearance of at least

5cm between the end of the

drain hose and the ground.

5cm

less

Do not place the end of the

drain hose in a hollow.

Ditch

5. Check if you flared the pipe correctly (see examples of incorrectly flared pipes below).

6. Align the pipes to connect them easily. Tighten the flare nuts first with your hands, and then with a torque wrench,

applying the following torque:

7. For further details on how to connect to the outdoor unit and purge the air, refer to page 38~40.

Correct

Uneven

Thickness

Cracked

Damaged

Surface

Inclined

• Excessive torque can be cause of gas leakage. In case brazing the pipe, the nitrogen gas must be blown into the

pipe (50 Pa). The joint must be accessible and serviceable.

• Tighten the flare nut with torque wrench according to specified method.

If the flare nut is over-tightened, the flare may break and cause refrigerant gas leakage.

Installing and connecting the drain hose of the indoor unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate.

When passing the drain hose through the 65-mm hole drilled in the wall, check the followings:

Maldives ZE_AR09FSFP@_IBIM_DB68-03379A_EN.indd 36

2012-12-8 9:09:08