eutech-instruments cyberscan ph 110 phmvrs232 meter User Manual

Instruction Manual   

 

CyberScan pH 11 / 110  

 

55

After matching the Communication Settings between your computer using Data 
Acquisition program and the pH 110 meter, you can now capture data into your 
computer for analysis and storage purposes. 

1.  Ensure the 1-meter RS232 communication cable (Refer to Accessories 

Section) is connected between the computer and the pH 110 meter’s Com 
port. Refer to section 3.4 “Connecting the RS232C Cable (Only For pH 110)” 
on page 9for connection procedure. 

2.  Switch on the pH 110 meter and run the Data Acquisition software. 

3.  Click “ENABLE CONNECTION” button. 

4.  With the pH 110 meter switched on, press the PRINT key to send data to the 

computer. See Figure 57 below. 

5.  You can use MODE key on the meter and change to other parameter such 

as mV or Rel mV and print data accordingly. 

6.  You can also check off the Time Stamp function, so as to print without the 

Time and Date information. 

7.  You can click Clear Readings button to begin another set of measurements, 

or click Save Readings to store readings for future retrieval.