Apple xserve 1.0.1 User Manual

50

Chapter  3

 

Connect Cables Directly to the Server

Once the server is secured in the rack, you can connect the cables and power cord directly to 
its back and front panels. You must connect the cables and power cord directly if you mount 
the server in a two-post rack.

Follow these steps to connect cables for network connections and peripheral devices directly 
to the server (without mounting the cable-management arm).

1

Gather the cables and devices you will connect to the server’s back panel. Make certain that 
each cable has the proper connector and that it is designed for use in a high-capacity server. 
(Check the documentation for each peripheral device or cable to determine that it can be 
used with the server.)

2

Label each cable so that you can locate a specific cable quickly and avoid errors when 
disconnecting cables.

3

Beginning at one side of the server’s back panel, connect each cable to the appropriate port.

4

Connect the power cord and its retaining clip to the back panel.

The ends of the clip fit into the small openings at either side of the power socket. Be sure 
that the rounded part of the clip goes under the cord, so that the cord is supported.

If more than one power cord came with your server, use the cord appropriate for the 
electrical service available at your location.

You can use the long power cord supplied with the server or another cord, such as one 
already installed in the rack.

5

If you will be using the FireWire port on the front panel of the server, connect a cable to it.

6

When all cables are in place, connect each one to its intended device.

Important  

When connecting peripheral devices, be sure to allow adequate space at the 

front and back of the server for proper airflow and access to the rack for servicing.