att 7620 User Manual
CORDLESS ANSWERING SYSTEM TELEPHONE 7620
•
•
•
•
Installation
Table Installation
1. Choose a spot near an electrical outlet and a telephone jack.
•
This phone requires a modular telephone jack and a standard (110v AC).
•
The outlet should not be controlled by a wall switch: if the switch is ever turned off, the phone will
not operate.
not operate.
2. Install the handset battery.
•
Remove the battery case cover on the handset by pressing on the indentations and sliding the cover
downward.
downward.
•
Plug the battery pack cord into the handset and rest the cords on top of the battery pack.
•
Replace the cover by sliding it on its track up over the battery compartment until it snaps firmly in
place.
place.
3. Insert the microcassette.
Lift the cover. Insert the cassette with the full reel to the right.
4. Set the dial mode switch on the bottom of the base to TT if you have touch-tone service or DP if you
have dial pulse/rotary service.
5. Set the ringer switch.
Set the switch to ON (the handset will ring) or OFF (the handset will not ring).
6. Connect the telephone line cord.
Plug one end of the telephone line cord into the jack on the top side of the base. Plug the other end of
the line cord into a modular jack. Make sure the plug snaps firmly into place.
the line cord into a modular jack. Make sure the plug snaps firmly into place.
7. Plug in the power cord.
Plug the AC adapter on the power cord into an electrical outlet.
8. Charge the handset batteries for 10 hours.
Place the handset in the base. The CHARGING light on the base goes on to show the handset is in the
right position to charge the batteries.
right position to charge the batteries.
9. Check for dial tone.
After the batteries are charged, pick up the handset and extend the base antenna. Press PHONE: the
PHONE light should go on and you should hear a dial tone.
PHONE light should go on and you should hear a dial tone.
Wall Mounting Installation
1. Follow steps 1-5 in TABLE INSTALLATION.
2. Choose and mark the mounting position.
2. Choose and mark the mounting position.
The mounting screws should screw into a wooden stud within the wall. Use the Wall Mounting
Template and a pencil to mark the screw positions on the wall.
Template and a pencil to mark the screw positions on the wall.
3. Install the mounting sleeves and screws.
Start the screw holes in the marks you made on the wall. Now slip the mounting sleeves onto the
screws, with the larger end of the sleeve toward the screw head. Insert the screws in the holes you
started, and tighten until the smaller end of the sleeve is flat against the wall.
screws, with the larger end of the sleeve toward the screw head. Insert the screws in the holes you
started, and tighten until the smaller end of the sleeve is flat against the wall.
4. Reverse the switch hook.