Audiovox vod85 User Manual
VHDIND
2
Powering the DVD Player
This system MUST be powered from switched (Accessory) power as indicated on the marking
label. Power should be applied to the unit when the ignition key is in the Run and/or Accessory
positions. Use only the supplied power cable provided with this set to avoid electric hazards.
label. Power should be applied to the unit when the ignition key is in the Run and/or Accessory
positions. Use only the supplied power cable provided with this set to avoid electric hazards.
Operation
When the temperature rises dramatically from a very low temperature, moisture may condense
inside the VHDIND and cause the DVD player to malfunction. If the VHDIND does not operate
properly under these conditions, leave the VHDIND turned on for at least 30 minutes to allow
the moisture to evaporate.
inside the VHDIND and cause the DVD player to malfunction. If the VHDIND does not operate
properly under these conditions, leave the VHDIND turned on for at least 30 minutes to allow
the moisture to evaporate.
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery
cable prior to installation.
cable prior to installation.
NOTE: If the VHDIND is to be installed in a car equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is disconnected,
the computer memory may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.
navigation computer, do not disconnect the battery cable. If the cable is disconnected,
the computer memory may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.
INSTALLATION
1.
Remove the two transport screws.
2.
Attach the mounting bracket to the player using the supplied screws.
3.
Attach the DVD player to the vehicle using the mounting brackets.
NOTE: For proper operation of the DVD player, the chassis must be mounted within 20°
of horizontal. Make sure the unit is mounted within this limitation.
of horizontal. Make sure the unit is mounted within this limitation.
4.
Connect the wiring adapter to the existing wiring harness.
5.
Complete wiring as illustrated in “Figure 2 - Wiring Diagram.”
6.
Reconnect the battery negative terminal.
NOTE: When replacing a fuse, be sure to use the correct type and amperage to avoid
damaging the radio.
damaging the radio.
7.
Turn the unit on to confirm operation (ignition switch must be on). If the unit does not
operate, recheck all wiring until the problem is corrected.
operate, recheck all wiring until the problem is corrected.
8.
Replace any items you removed from the dashboard.
9.
Reinstall the dash panel.
Screw M 3
6
Screw M 3
6
Figure 1 - Installation
Figure 2 - Wiring Diagram