3M individual wrapped mask tape User Manual

p r o j e c t :

 2011 Flyer Revise

c l i e n t :

 3M AAD

d a t e :

 03.30.05

v e r s i o n :

 Masking Flyer v1.ai

n o t e s :

 _____________________________

___________________________________

___________________________________

___________________________________

i n k   s p e c s :

p h :   7 6 3 . 5 9 3 . 1 3 3 9

c

m

y

k

pms pms pms pms pms

Cool removal: Adhesive is firm and 
removal is generally clean. However, 
excessively cold temperatures can 
cause the tape to become brittle 
and tear (<50˚F).

Normal removal: Counteracts negative 
effects of hot and cold removal. The 
adhesive is firm enough for clean removal 
and yet is not so firm as to increase 
adhesion to a point where tearing occurs. 
Removal temperatures of 50˚F-100˚F are 
recommended.

Warm removal: Increases 
adhesive transfer possibilities, 
but less effort is required to 
remove tape (>100˚F).

Avoid stretching tape: Pull tape off roll a few feet at a time 
and press down a small area without stretching. The tape 
backing is designed to conform to curved surfaces. If 
shrinking should occur during spraying or drying, it is 
desirable to have as much stretch left in the tape as possible.

Lay tape into surface depressions: If it is stretched and 
forced down, the tape may lift up or, in some cases, break.

Press edge of tape down firmly: In all two-color 
masking, where a sharp color separation is desired, it is 
imperative to press the edges of the tape down firmly. 
This will help prevent seepage and jagged paint lines.

Speed of removal: 
Moderate speeds are best. 
Excessive rate of removal 
may cause tearing. Very 
slow rate of removal 
increases tendency to 
transfer adhesive.

Angle of removal:
A 45˚ angle works best. 
Remove tape back on 
itself as shown in 
illustration. If adhesive 
begins to transfer, remove 
tape at a 90˚ angle.

46334 

18mm X 55m 

(3/4" applicators)

 1  48

46338 36mm 

X 

55m 

(1 1/2" applicators)

 1  24

• Improved adhesive

 transfer resistance

• Highly conformable
• Provides outstanding paint lines

46545 

18mm X 55m 

(3/4" applicators)

 1  48

46547 36mm 

X 

55m 

(1 1/2" applicators)

 1 

24

• Consistent unwind
• Excellent paint edge

• Consistent adhesive coating
• Adhesive transfer resistance

Scotch and 3M are trademarks of 3M

© 3M 2004

All rights reserved

60-4400-9974-9

Automotive Aftermarket Division
3M Center, Building 223-6N-01
St. Paul, MN 55144-1000

NASCAR® and NASCAR Performance® are registered trademarks of

the National Association for Stock Car Auto Racing, Inc.