Sony cdp-c250z User Manual
Additional Information
19
Additional Information
LINE OUT
DIGITAL OUT
(OPTICAL)
(CDP-CE505/
C450Z only)
(OPTICAL)
(CDP-CE505/
C450Z only)
PHONES
(CDP-CE505/
C450Z only)
(CDP-CE505/
C450Z only)
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
/
Adjust the playback level using the PHONE
LEVEL control on the player (CDP-CE505 and
CDP-C450Z only) or LINE OUT LEVEL +/– on
the remote (except for CDP-CE305, CDP-C250Z
and CDP-C661).
CDP-C450Z only) or LINE OUT LEVEL +/– on
the remote (except for CDP-CE305, CDP-C250Z
and CDP-C661).
The CD does not play.
/
There’s no CD inside the player (“no DISC”
appears). Insert a CD.
/
Place the CD with the label side up on the disc
tray correctly.
/
Clean the CD (see page 18).
/
Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 2).
for about an hour (see page 2).
The remote does not function. (except for CDP-CE305,
CDP-C250Z and CDP-C661)
/
Remove the obstacles in the path of the remote
and the player.
/
Point the remote at the remote sensor g on the
player.
/
Replace all the batteries in the remote with new
ones if they are weak.
The player functions incorrectly.
/
The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the player.
back on to reset the player.
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output
Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
CDP-CE505/C450Z: More than 107 dB
CDP-CE405/CE305/C350Z/C250Z
/C661: More than 102 dB
CDP-CE405/CE305/C350Z/C250Z
/C661: More than 102 dB
Dynamic range
More than 98 dB
Harmonic distortion
CDP-CE505/C450Z: Less than 0.0035%
CDP-CE405/CE305/C350Z/C250Z
/C661: Less than 0.0045%
CDP-CE405/CE305/C350Z/C250Z
/C661: Less than 0.0045%
Channel separation
More than 100 dB
Output
Jack
type
Phono
jacks
Optical
output
connector
connector
Stereo
phone jack
Maximum
output
level
output
level
2 V
(at 50 kilohms)
(at 50 kilohms)
–18dBm
10 mW
Load
impedance
impedance
Over 10 kilohms
Wave length: 660nm
32 ohms
Where purchased␣
USA
Australia
Power requirements
120 V AC, 60 Hz
240 V AC, 50/60 Hz
General
Power requirements
Power consumption
14 W
Dimensions (approx.)
430
×
120
×
385 mm
(w/h/d)
(17
×
4 3/4
×
15 1/4 in.) incl. projecting
parts
Mass (approx.)
5.6 kg (12 lbs 6 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (except for CDP-CE305,
CDP-C250Z and CDP-C661) (1)
Sony SUM-3 (NS) batteries (except for CDP-CE305, CDP-
C250Z and CDP-C661) (2)
Remote commander (remote) (except for CDP-CE305,
CDP-C250Z and CDP-C661) (1)
Sony SUM-3 (NS) batteries (except for CDP-CE305, CDP-
C250Z and CDP-C661) (2)
Design and specifications are subject to change without notice.