Sony CMT-GPX9DAB User Manual
T
rou
b
b
les
hooti
hooti
n
g
29
GB
“TUNED” does not appear in the display
(DAB only).
(DAB only).
• Check all aerial connections, then press TAPE x
and TUNING MODE on the unit simultaneously
to perform the DAB Automatic Scan.
to perform the DAB Automatic Scan.
• The current DAB service is not available. Press +
or – (or TUNING + or – on the unit) to select a
different service.
different service.
• If you have moved to another area, some services/
frequencies may have changed and you may not
be able to tune into your usual broadcast.
Perform the DAB Automatic Scan procedure to
re-register the contents of broadcasts.
(Performing this procedure clears all previously
stored presets.)
be able to tune into your usual broadcast.
Perform the DAB Automatic Scan procedure to
re-register the contents of broadcasts.
(Performing this procedure clears all previously
stored presets.)
“NO SERV” is displayed (DAB only).
• Check all aerial connections, then press TAPE x
and TUNING MODE on the unit simultaneously
to perform the DAB Automatic Scan.
to perform the DAB Automatic Scan.
“SCANNING” does not disappear.
• Depending on the DAB services available in your
area, scanning may take a few minutes.
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
decrease in sound level.
• The heads are dirty. Clean them (page 32).
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
There is excessive wow or flutter, or the sound
drops out.
drops out.
• The capstans in the tape deck are dirty. Clean
Noise increases or the high frequencies are
erased.
erased.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 32).
(page 32).
• The tape has wound to the end.
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 27) and check the condition of the system.
• Connect the component properly (page 25) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the mains lead.
2
Reconnect the mains lead.
3
Press ?/1 to turn on the system.
4
Press CD x, DSGX and ?/1.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
should set the settings you made, such as the
preset stations, clock, and timer.