Sony DAV-X10 User Manual
masterpage:Right
specdef v20060111
filename[G:\FM\Sony\0607\DAV-X10_CEL\Source\3210565321DAVX10\gb04gsb.fm]
model name [DAV-X10]
[3-210-565-32(1)]
19
GB
Gettin
g
Star
ted
– B
A
SI
C
C
–
11
Press .
The [AUTO CALIBRATION] display
appears.
appears.
12
Connect the calibration mic to the
A.CAL MIC jack on the rear panel, and
set it up at the ear level using a tripod,
etc. (not supplied).
A.CAL MIC jack on the rear panel, and
set it up at the ear level using a tripod,
etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
13
Press
X/x to select [YES], then press
.
[AUTO CALIBRATION] starts. Be quiet
during the measurement.
during the measurement.
Note
• Loud test sound is output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
volume down. Give consideration to children
and neighbors.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
takes about 1 minute), as it may interfere with
measurement.
14
Unplug the calibration mic and press
C/
c to select [YES].
Quick Setup is finished. All connections
and setup operations are complete.
Quick Setup is finished. All connections
and setup operations are complete.
Note
• The environment of the room in which the
system is installed may affect measurements.
• If measurement fails, follow the message then
retry [AUTO CALIBRATION].
To quit the Quick Setup
Press
DISPLAY in any Step.
Tip
• If you change the position of the speakers, reset the
speaker settings. See “Calibrating the Appropriate
Settings Automatically” (page 79).
Settings Automatically” (page 79).
• If you want to change any of the settings, see “Using
• If there is no sound from the speakers, check the
speaker connection.
To recall the Quick Setup display
1
Press
DISPLAY when the system is in
stop mode.
The Control Menu display appears.
2
Press
X/x to select
[SETUP], then
press .
The options for [SETUP] appear.
Connect calibration mic. Start
measurement?
measurement?
YES
AUTO CALIBRATION
NO
SPEAKER
IMPEDANCE USE 4
EURO AV OUTPUT(TO TV)
COMPONENT VIDEO OUT
Y
Y
PB /
CB
PR /
CR
SAT/CABLE IN
SAT/
CABLE
CABLE
TV
VIDEO
DIGITAL IN
AUDIO
R
COAXIAL
OPTICAL
OPTICAL
L
ANTENNA
DMPORT
AM
OUT
75 COAXIAL
(DVD
ONLY)
ONLY)
(DVD ONLY)
2
1
FM
ECM-AC2
A.CAL
MIC
ECM-AC2
A.CAL
MIC
Calibration mic
FRONT L :
FRONT R :
SUBWOOFER :
FRONT R :
SUBWOOFER :
If OK, unplug calibration mic and select
“YES”.
“YES”.
YES
3.12m 0.0dB
3.35m + 0.5dB
3.35m + 1.0dB
3.35m + 0.5dB
3.35m + 1.0dB
Measurement complete.
NO
continued