Sony HT-SF370 User Manual

The table below shows the display when 
measurement starts.

• If “CHECK MIC” appears, you cannot perform 

the Auto Calibration. Connect the optimizer 
microphone, then perform the Auto Calibration 
again.

• If “PHONES” appears, you cannot perform the 

Auto Calibration. Disconnect the headphones 
from the S-AIR product you are using, then 
perform the Auto Calibration again.

• When Auto Calibration starts:

– Stand some distance from the speakers and the 

listening position to avoid measurement failure. 
This is because test signals are output from the 
speakers during measurement.

– Avoid making noise to get a more accurate 

measurement.

• The Auto Calibration function will be canceled 

when you do the following during the 
measurement process:

– Press ?/1 or MUTING.
– Press input buttons on the remote or INPUT 

SELECTOR +/– on the receiver.

– Change the volume level.

When the measurement ends, a beep 
sounds and the measurement result 
appears on the display.

V/v repeatedly to select 

After “SAVE EXIT” is displayed for 50 
seconds, the measurement result is saved 
automatically, without the need to save the 
procedure.

Select “SAVE EXIT” in step 2.
The measurement results are saved.

Speaker existance

TONE

Speaker gain, distance, 
frequency response

T. S. P.

Subwoofer gain and 
distance

SUBWOOFER

When the 
measurement 
process 
completes 
properly

SAVE 
EXIT

Proceed to step 
2.

When the 
measurement 
process fails

ERROR 

 

XXXX

SAVE EXIT

Saves the measurement 
results and exits the setting 
process.

WRN CHECK

Displays warning 
concerning the 
measurement results. See 
“When you select “WRN 
CHECK”” (page 28).

DIST INFO

Displays the measurement 
result for speaker distance.

LEVEL INFO

Displays the measurement 
result for speaker level.

EXIT

Exits the setting process 
without saving the 
measurement results.