Sony storstation lib-d81 User Manual
21
Chapter 2 Installation
Setting the SCSI ID
Use the SCSI ID switches at the back of the AIT autoloader to set the AIT drive
and/or AIT autoloader SCSI ID.
and/or AIT autoloader SCSI ID.
The default settings of the switches are as follows.
Use the upper switch to set the AIT drive SCSI ID and the lower switch to set
the AIT autoloader SCSI ID.
Use the upper switch to set the AIT drive SCSI ID and the lower switch to set
the AIT autoloader SCSI ID.
Caution
• Do not set the same SCSI ID for the AIT drive and AIT autoloader.
• Make sure that you perform these settings before turning on the AIT
• Make sure that you perform these settings before turning on the AIT
autoloader.
1
Make sure that the power switch on the rear of the AIT autoloader is in the
off position (a is depressed).
off position (a is depressed).
2
Use a pointed object such as a machinist’s screwdriver to turn the switches
until their arrows match the setting that you want.
until their arrows match the setting that you want.
3
Press the power switch to turn on the power.
If you want to connect SCSI peripheral devices, see “Connecting SCSI
Peripheral Devices” (page 22).
Peripheral Devices” (page 22).
4 5 6
7
8
9
A
B
3
2
1
0
F
E
D
C
4 5 6
7
8
9
A
B
3
2
1
0
F
E
D
C
AIT drive SCSI ID
AIT autoloader SCSI ID