Sony VPL-VW60

55

 

Others

The picture flickers.

c Activate “APA”, then adjust the current input signal.
c Adjust “Phase” for “Adjust Signal” in the Screen 

 menu 

properly. (

The color of characters or 
the picture is not 
appropriate.

c Select the desired color registration in “Panel Alignment” of 

Installation 

On-screen display does not 
appear.

c Set “Status” in the Setup 

 menu to “On.” (

c Check if the 

?

/

1

 (ON/STANDBY) indicator should light in 

green.

The model name does not 
disappear from the screen.

c The display mode of the projector may be set at the time of 

purchase. Consult with your local dealer or qualified Sony 
personnel.

The remote control does 
not work.

c Batteries could be weak. Replace them with new batteries. 

c Insert the batteries with the correct polarities. (1 page 11)
c In the Installation 

 menu, set the setting of “IR Receiver” to 

“Front & Rear”. (

c If there is a fluorescent lamp near the remote control detector, the 

projector may work improperly or inadvertently. Change the 
setting of “IR Receiver” in the Installation 

The fan is noisy.

c Check the setting of “Cooling Setting” in the Setup 

 menu. 

c Make sure that the room temperature is not too high.

Check the installation conditions. (

The number of fan rotation increases to maintain the product 
reliability of the projector’s components in a room, where the 
temperature is higher than normal. The fan noise becomes 
slightly louder. The approximate normal temperature is 25°C.