Nokia 6220 Service Manual

CCS Technical Documentation

                                Company confidential 

RH-20

Issue 1  10/2003

Nokia Corporation.

Page 23

Connect test jig to computer with DAU-9S cable or to FPS-8 Flash Prommer with XCS-4 
modular cable. 

Make sure that you have PKD-1 dongle connected to computers parallel port.

Connect DC power supply to module test jig with FLC-2 cable. 

Set  the DC  supply voltage to 4.2V.

Connect an RF-cable to the module test jig (MJS-38) RF connector and to RF signal gen-
erator. 

Set the phone module to test jig and start Phoenix service sofware.

Initialize connection to phone. (use FBUS driver when using DAU9S and COMBOX driver 
when using FPS-8)

Choose product from the menu

File -> Choose product -> RH-20

From toolbar set operating mode to "Local"

Activate RF controls window from the menu

Testing -> RF Controls

From the RF controls window:

- Select band "GSM900", "GSM 1800" or “GSM1900” (Default = "GSM900")

- Set Active unit to "Rx"  (Default = "Rx")

- Set Operation mode to "Burst" (Default = "Burst")

For continuous mode:

- Set Operation mode to "Continuous"

- Set AGC to "12: FEG_ON + DTOS_ON + BB_30=Vgain60” (maximum gain setting used 
in normal mode)

 (Default = "14: FEG_ON + DTOS_ON + BB_42=Vgain72")

- Set Rx/Tx channel to 37 on GSM900 band, 700 on GSM1800 band or 661 on GSM1900