kymco mo movie125150 Service Manual

REMOVAL
1. Remove the front right side cover. (!2-4)

2. Disconnect all the tubes that go to the air

injection cut-off valve.

3. Remove the air injection cut-off valve.

INSPECTION
1. Inspect the air injection cut-off valve

flow using a vacuum pump.  If the flow is

not within the specified values, replace

with a new one.

2. The flow should be at least 30 liter/min

when a vacuum of 250mm/Hg is applied.

3. The flow should be at least 1.6 liter/min

when a vacuum of 320mm/Hg is applied.

4. Check each connecting tube for cracks or

damage and replace if necessary.

INSTALLATION
1. The installation sequence is the reverse of

removal.

• When installing, be careful not to bend or twist the tubes

and check for proper installation.

• The tube length is very important to its performance, use

the tube of same specification for replacement.

＊

Vacuum Tube

Bolt

Air Injection Cut-off Valve

Vacuum Pump

Tube to Reed Valve

Air Inlet Tube

Air Injection Cut-off Valve