Enviro sienna indoor gas fireplace User Manual

Page of 32
Secondary Installation
Figure 29: Filler panel with trim installation.
I
NSTALLATION
 
OF
 S
URROUND
 P
ANEL
:
The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the 
filler panel with trim. If you have trim for your filler panel, the trim must be installed before installing the 
filler panel onto the unit.
Figure 28: Screw to 
hold the trim against 
the surround.
Figure 26: Corner brackets 
for trim.
1. Attach one side trim to the top trim using a corner bracket (see Figure 
26) to secure pieces together. There are two (2) main pieces to each 
corner bracket (see Figure 27). When installing the corner pieces into 
the trim the “B FACE” sides must face each other and the screw heads 
are to face out. With the bracket in place and the top and a side trim 
snug together use a flat head screwdriver to turn the two (2) screws in 
the bracket in to tighten it into the trim.
2. Slide the two (2) attached trim pieces onto the surround panel.
3. Attach the other side trim piece to the top trim using the same method 
used in Step 1.
4. Place  the  second  side  of  the  trim 
on  the  surround  panel  in  the  same 
manner  use  on  the  first  side  and 
secure in the same manner.
5. On the side trims there are holes 2” (50 
mm) from either end. Using a Phillips 
screwdriver to place a #8 screw 11⁄4” 
long  in  each  hole  and  tighten  (refer 
to Figure 28). This will keep the trim 
tight against the surround. 
NOTE: The notch at the bottom of the 
left trim is so the power cord can be 
run to the outside of the panel.
INSTALLATION:  Lift  the  surround  upright  in 
front  of  the  fireplace  with  the  four  (4)  hooks 
pointing towards the fireplace. Slide the hooks 
into  their  corresponding  slots  (see  Figure  29). 
Ensure  the  hooks  are  pushed  all  the  way  into 
the slots and the notch on the hook must be on 
the bottom of the slot. The surround should be 
wiped with a damp cloth periodically.
REMOVAL:  Lift  the  surround  straight  up  in 
order  to  unhook  the  notch  on  the  hooks  from 
the  bottom  of  the  slots.  Pull  the  surround  out 
away  from  the  fireplace.  Place  the  surround 
where it will not be damaged.
20
Figure 27: Two pieces of corner bracket.