Havis-Shields kk-st-flip User Manual
INSTALL INSTRUCTIONS KK-ST-FLIP
FLIP DOWN REAR STEP OPTION
(For Rear Permanent Mount Step order with KK-x-ST-RP)
TOOLS REQUIRED:
Ratcheting
Ratcheting
wrench
Standard socket set
Open-end wrench set
Open-end wrench set
Power drill
Drill bit set
Drill bit set
HARDWARE:
QTY DESCRIPTION PART
QTY DESCRIPTION PART
#
10
½” x 1 ½” Hex head bolt
GSM33050
4
½” x 3 ½” Hex head bolt
GSM33055
32
½” Flat washer
GSM31012
10
½” Lock washer
GSM31030
4
½” Nylock nut
GSM30020
10
½” Hex nut
GSM30011
2
¼” Stainless nylock nut
GSM30046
SUB ASSEMBLY:
1. Confirm receipt of all parts.
2. Flip down portion of step will come assembled.
3. Slide Support Channels into the Step.
4. Bolt together using (4) ½” x 4” Hex Head Bolts, ½” Nylock Nuts, ½” Flat Washers.
2. Flip down portion of step will come assembled.
3. Slide Support Channels into the Step.
4. Bolt together using (4) ½” x 4” Hex Head Bolts, ½” Nylock Nuts, ½” Flat Washers.
Note: Be sure that flat side of Support Channels face towards outside of vehicle
INSTALLATION:
1. MOUNT FRAME BRACKETS:
• Determine Driver and Passenger side Frame Brackets using view on final page.
• Line brackets up with holes in frame rail of vehicle.
• Bolt brackets to frame using (4) ½” x 1 ½” Hex Head Bolts, ½” Hex Head Nuts,
• Bolt brackets to frame using (4) ½” x 1 ½” Hex Head Bolts, ½” Hex Head Nuts,
½” Flat Washers, and ½” Lock Washers
• Do not tighten hardware at this time.
Note: FORD VANS Only: You must use a spacer between the Frame Rail and the Frame
Bracket on the forward mounting holes. Use (2) ½” Supplied flat washers
2. MOUNT STEP AND RAIL ASSEMBLY:
• Step can be mounted at various heights.
• With height determined, loosely bolt Assembly to Frame Brackets using (6)
½” x 1 ½” Hex Head Bolts, ½” Hex Head Nuts, ½” Flat Washers, and ½” Lock
Washers
Washers
3. FINAL SQUARING:
• With step square at desired height, tighten all hardware.