Auto Page rs-855lcd User Manual
15
1. Press
first, within 3 seconds press and hold
and
buttons at the same time for 2 seconds . One long beeping
sound and the “
” timer icon will be displayed on the
LCD screen indicating the system is back to the first
transceiver pin code.
transceiver pin code.
2. While the “
” timer icon is displayed on the LCD
screen, you can remote control and communicate with the first
vehicle security system. It has one short “bi” soun d while
pressing the button of the LCD screen transceiver.
vehicle security system. It has one short “bi” soun d while
pressing the button of the LCD screen transceiver.
Y. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to
remember its alarm state if the power is lost and then reconnected
.
remember its alarm state if the power is lost and then reconnected
.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button once on the transmitter.
2. The parking light will activate to indicate the remote start
received the signal.
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking
light will turn on again and climate controls will activate and adjust
the vehicles interior temperature to your preset setting. (While the
vehicle is running, the “minutes” digit on the LCD screen will flash
and the will indicate count down timer based on the 5, 10, 20 or
30 minute run time set up by your installation center.)
5. The vehicle will run for 5 to 30 minute cycle automatically shut
down. (When the unit shuts off the count down timer will turn off
and the transmitter will play a melody.)
received the signal.
3. The engine will start approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking
light will turn on again and climate controls will activate and adjust
the vehicles interior temperature to your preset setting. (While the
vehicle is running, the “minutes” digit on the LCD screen will flash
and the will indicate count down timer based on the 5, 10, 20 or
30 minute run time set up by your installation center.)
5. The vehicle will run for 5 to 30 minute cycle automatically shut
down. (When the unit shuts off the count down timer will turn off
and the transmitter will play a melody.)
NOT E: The Remote Start Unit will not start the vehicle if any one of the
following conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF
position. (If installed)
4. The gear selector is in any gear other then “PARK” or
“NEUTRAL”
1. The hood is opened.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to OFF
position. (If installed)
4. The gear selector is in any gear other then “PARK” or
“NEUTRAL”
Activate Remote
Start
Start
Engine Running
SAFE START (Child safety mode)
Factory defaults setting to press the
button twice on the transmitter to
start the vehicle. Programming this feature to eliminate an accidental remote
start,
start,
1. The user presses the transmitter
buttons twice within 3 seconds to
start the vehicle. or