Autostart as-1251 User Manual

User Guide 

P. 3 

Remote Starting Your Vehicle 

If your vehicle has an automatic transmission, simply press the 

Ι button to remote start or the 

ΙΙ button to stop your vehicle. Please see “Remote starting” below. 
Warning: If your vehicle has an automatic transmission and the parking lights flash 15 times after 
pressing the 

ΙΙ button, please see your installer as programming will have to be modified. 

Setting Your Vehicle Into Ready Mode 

If your vehicle has a manual transmission you must read the following indications. In order to start the 

vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready Mode, it 

cannot remote start the vehicle. 

Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time. The 

system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is pressed, if 

the parking brake is disengaged or if the ignition key is turned to the

 

 

position. 

To set the system to Ready Mode: 

1. 

Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral 

position. 

2. 

With the engine already running, apply the 
parking brake once and release the brake 
pedal. 
Make sure to release the brake pedal. 

2. 

With the engine already running, apply the 
parking brake twice and release the brake 
pedal. 
Make sure to release the brake pedal. 
The parking lights will flash 3 times 
quickly and remain lit. 
Skip to step 4. 

3. 

Within 20 sec. of engaging the parking brake, 
press and hold 

Ι 

or 

ΙΙ 

on the transmitter. 

The parking lights will flash 3 times 
quickly and remain lit. 

- 

4. 

Remove the key: the engine will continue running. 

5. 

Exit the vehicle and close all doors, hood and trunk. 

6. 

Press for approx. 1 second either button: 

Ι 

or 

ΙΙ.

 

Remote Starting 

Press the 

Ι button for approx. 1 second. The parking lights will come 

 and the transmitter will beep 

once to inform you that the remote starter has received your signal. Approximately 5 seconds later, the 

engine will start. The transmitter will beep 3 times and the parking lights will remain 

 during the pre-

programmed run time of the engine. 

If the vehicle does not start at the first attempt, the system will shut down. If your vehicle is equipped 

with an automatic transmission, there will be 3 start attempts before the system gives up. 

Driving Off 

With the vehicle running under remote start, press the button 

Ι to disarm the security system (if button 

Ι is programmed as 

 or 

 button). Enter the vehicle and do the following: 

1.  Turn the ignition key to the 

 position. (Do not turn the key to the 

position 

while the engine is running. This will cause the starter motor to re-engage.) 

2.  Press the brake pedal to disengage the remote starter unit. 

You are now ready to drive off.