Autostart as-6070 tw User Manual

AS-6070 TW User Guide

P. 15

Car Finder 
(Enabled by default.) When enabled, the Car Finder option will help you locate your vehicle by 
generating a pulsating signal through the horn or the siren. To hear the signal, press the 

 and 

 buttons simultaneously. This will cause a pulsating signal lasting for the time you keep the 

buttons pressed. 

Siren or Horn Chirp Timing 
The duration of the chirps can be adjusted at installation (from 5 to 200 ms). 

Safe Start 
(Disabled by default.) If this feature is enabled, the user must press the 

 button 2 times 

within 3 seconds to remote-start the vehicle. This will eliminate accidental remote starts, e.g. when 
children are playing with the transmitter. 
If Swap Start Mode is selected, to remote-start your vehicle press 

 and 

simultaneously. The 

 output can be activated by pressing the 

 button. 

Home Valet 

TM

(Disabled by default.) If this feature is installed, the user will have the possibility to remotely set the 
vehicle to a no-remote-start mode. See Home Valet section, earlier in this Guide, for full 
instructions. 

Ignition-controlled Door Locks 
(Enabled by default.)This is an added security feature. If your Systems was installed with the 
Ignition-Controlled Door Locks option, the doors will automatically be locked as soon as the ignition 
key is turned to the 

 position while the brakes are pressed. When the key is turned 

to the 

 position, the doors will automatically be unlocked. 

Ignition Re-lock 
On Systems of this series, when Ignition-controlled Door Locks are enabled and the ignition key is 
in the 

 position, should any door be unlocked and opened, all doors will be 

relocked next time the brake pedal is pressed. 

Secure Lock 
(Disabled by default.) Before it can remote-start your vehicle, the System must first disarm the 
factory security system. The Secure Lock feature may be required on certain vehicle models with 
factory security systems that automatically unlock the doors when the security system is disarmed. 
To keep your vehicle protected when the factory security system is disarmed for a remote start, 
Secure Lock will relock your doors as soon as the vehicle has started. Once the engine run cycle 
ends, Secure Lock will rearm your factory security system. 

Turbo Mode 
(Disabled by default.) When left in Turbo Mode, the System will keep the engine running for 
60 seconds before shutting it down. This is to allow a turbocharger to idle down after the user 
leaves the vehicle. See Turbo Mode section earlier in this Guide. 

Remote Trunk Release 
If your system was installed with the Remote Trunk Release option, you can open your trunk by 
pressing the 

 button for 3 seconds on the remote transmitter or by pressing the 

 button 

 within 3 seconds. 

Engine Run Time 
(15/20 minutes by default.) If you have a gas engine, your System can be programmed to run the 
engine for 4, 15, or 25 minutes (15 minutes by default). If you have a diesel engine, the System 
can be programmed to run the engine for 9, 20, or 30 minutes (20 minutes default).