Tektronix CFG280 User Manual

Reference

CFG280 User Manual

3. Connect another channel of the oscilloscope to the device under

test (see Figure 5).

4. Push the SWEEP button out on the function generator to

deactivate the internal sweep function.

5. Turn the FREQUENCY dial to the desired sweep start frequency

(the lowest point on the sweep).

6. Push the SWEEP button in to enable the internal sweep function.

7. Pull the SWEEP RATE knob out to lock the function generator

at the sweep stop frequency (the highest point on the sweep).

8. Adjust the sweep stop frequency with the SWEEP WIDTH

knob.

9. Now push the SWEEP button in to activate the internal linear

sweep. Use the SWEEP RATE knob to adjust the sweep rate.

To use the external sweep function, follow these steps:

1. Connect the MAIN OUT connector on the CFG280 Function

Generator to the oscilloscope input connector (see Figure 6).

CFC280

Voltage source

To VCF INPUT
(on rear panel)

MAIN OUT

Test oscilloscope