Ariston ASL70C User Manual
4
GB
Choosing a programme
1.
Plug the dryer into the electrical socket.
2.
Sort your laundry according to fabric type (
see
Laundry
).
3.
Open the door and make sure the filter is clean
and in place and the water container is empty
and in place (
and in place and the water container is empty
and in place (
see Maintenance
).
4.
Load the machine and make sure items are not
in the way of the door seal. Close the door.
in the way of the door seal. Close the door.
5.
If the On/Off light is not lit: Press the ON/OFF
button .
button .
6.
Choose a programme by checking the Programmes
Guide (
Guide (
see Programmes
) as well as the indications
for each type of fabric (
see Laundry
).
- Select a programme by rotating the
PROGRAMMES knob.
PROGRAMMES knob.
7.
Set a delay time and other options if necessary.
8.
If you wish to select the buzzer sound, at the end
of the progamme, press the ALARM Option button.
of the progamme, press the ALARM Option button.
9.
Press the START button to begin.
During the drying programme, you can check on
your laundry and take out items that are dry
while others continue drying. When you close
the door again, press the START button in order
to resume drying.
During the drying programme, you can check on
your laundry and take out items that are dry
while others continue drying. When you close
the door again, press the START button in order
to resume drying.
10. During the last few minutes of Drying
Programmes, before the programme is
completed, the final COOL TUMBLE phase is
entered (fabrics are cooled), this phase should
always be allowed to complete.
completed, the final COOL TUMBLE phase is
entered (fabrics are cooled), this phase should
always be allowed to complete.
11. When the programme is complete. The buzzer
will sound if Alarm option was selected.
Open the door, take the laundry out, clean the filter
and replace it. Empty the water container and
replace it (
Open the door, take the laundry out, clean the filter
and replace it. Empty the water container and
replace it (
see Maintenance
).
If the Post Creasecare option has been selected
and you do not remove the laundry immediately,
the dryer will tumble occasionally for 10 hours or
until you open the door.
and you do not remove the laundry immediately,
the dryer will tumble occasionally for 10 hours or
until you open the door.
12. Unplug the dryer.
Start and Programmes
Easy Iron Programme
‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The
cycle relaxes the fibres and makes them easier to iron and fold.
!
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The
cycle relaxes the fibres and makes them easier to iron and fold.
!
‘Easy Iron’ is
not a drying programme
and should not be used for wet articles of clothing.
For best results:
1.
1.
Do not load more than the maximum capacity.
These numbers refer to the dry weight:
These numbers refer to the dry weight:
Fabric
Maximum load
Cotton and Cotton mixtures
2.5kg
Synthetics
2kg
Denim
2kg
2.
Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put
them away in the closet. Should this not be possible repeat the programme.
them away in the closet. Should this not be possible repeat the programme.
The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton
mix, and less well on acrylic fibres and on materials such as Tencel®.
mix, and less well on acrylic fibres and on materials such as Tencel®.