Auto Page rs-1000 User Manual

                     

RS1000 OP 1/07 

17

 
P. DRIVER PAGING / LOST & FOUND   

This feature is useful in the event that someone wants to page the driver of the parked vehicle or you 
cannot find his OLED remote transceiver. 

If the ignition switch is in the “off” position, press and hold the valet switch for 2 
seconds to page the driver. One chirp sound shall be emitted from the vehicle and the 
paging melody will sound from your Remote OLED transceiver. “DRIVER PAGING” 
indication will flash on the OLED screen. 

(optional) 

If someone tries to page you by tapping the paging (knock) sensor, the paging melody will sound on your 
Remote OLED transceiver and “DRIVER PAGING” indication will flash on the OLED screen. The knock 
sensor is usually located on the driver’s side of the front windshield.   

1. 

Spin up the

   

switch to the page

 4

 and then press the “Driver Pager” button. It will respond with chirps 

from the vehicle. A melody sound and “DRIVER PAGING” indication flashes on the OLED screen to 

confirm the function has been turned ON.

2. When tapping the paging (knock) sensor on the vehicle, one chirp sound will be emitted and the paging 

melody will sound from you Remote OLED transceiver. The “DRIVER PAGING” indication will flash on 
the OLED screen. 

3. Turning ON the ignition switch or pressing the 

 button or    button will exit the driver paging mode. 

Q. DOME LIGHT CONVENIENCE DELAY & SUPERVISION 

The alarm has a unique feature, which will turn on your vehicle’s dome light as follows: 
1. Upon disarming, the interior light will remain on for 30 seconds. 
2. If the vehicle is intruded, the interior light will flash for the same duration as the siren. 
Note: Turning ON the ignition switch or arming the alarm will turn off the dome light. 

 

If the vehicles power door locks have been interfaced to the security system, the system will automatically 
lock the vehicle's doors in 3 seconds when the ignition is turned “ON” and /or unlock the vehicle’s doors 
when the ignition is turned “OFF”. (Programmable) 

  Press and hold 

  button on the transmitter for three seconds to remotely control the 

trunk release or other electric devices.   

 

   

Activate The Channel 4: Spin up the

   

switch to the page

 3

 and then press the “Channel 4” button or 

press the transmitter 

 and 

  buttons at the same time to active Channel 4 function.   

Activate The Channel 5: Spin up the

   

switch to the page

 3

 and then press the “Channel 5” button or 

press the transmitter 

 and 

  buttons at the same time to active Channel 5 function.   

Activate The Channel 6: Spin up the

   

switch to the page

 3

 and then press the “Channel 6” button or 

press the transmitter 

 and 

  buttons at the same time to active Channel 6 function.   

 

 

Your remote transmitter can be utilized to control multi- vehicle security system, to program the remote 
control transmitter to a second vehicle, follow the instructions for Transmitter programming. All 
programming parameters will be the same except for the following: 
For Regular Remote Control Transmitter: 

1. Prior to pushing any button on the transmitter. Press the Select 

II

 button first on the transmitter. 

2. Once 

II

 button is pressed the LED on the transmitter will illuminate for 3.5 seconds to indicate the 

second transmitter pin code is ON. 

3. While the LED is illuminated, press any button on the remote control transmitter to control a second 

vehicle security system.