Siig 104-0722A User Manual
3
Hardware Installation
General instructions for installing the card are
provided below. Since the design of computer
cases and motherboards vary, refer to your
computer’s reference manual for further
information, if needed.
Static Electricity Discharge may permanently
damage your system. Discharge any static
electricity build up in your body by touching your
computer’s case for a few seconds. Avoid any
contact with internal parts and handle cards
only by their external edges.
1.
provided below. Since the design of computer
cases and motherboards vary, refer to your
computer’s reference manual for further
information, if needed.
Static Electricity Discharge may permanently
damage your system. Discharge any static
electricity build up in your body by touching your
computer’s case for a few seconds. Avoid any
contact with internal parts and handle cards
only by their external edges.
1.
Turn OFF the power to your computer and
any other connected peripheral devices.
2.
Unplug the power cord and remove the
cover from the computer.
3.
Remove the slot bracket from an available
PCI slot.
4.
Connect the 2-Port DB9 (9-Pin) serial port
cable
connector now and remove another
slot bracket cover from from the system
chassis. See Figure 1 on page 2 for more
details. Skip this step if you only need two
chassis. See Figure 1 on page 2 for more
details. Skip this step if you only need two