Edelbrock 5262 User Manual

©2007 Edelbrock Corporation
Catalog #5262

Brochure #63-0363

Rev. 8/07 - DA/mc

Please study these instructions carefully before installing your new Panhard Rod. If you have any questions, please contact
our  Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time or 
e-mail us at edelbrock@edelbrock.com. Please fill out and mail your warranty card.

Application: Designed for full size GM SUVs. This panhard rod is designed to stabilize the rear suspension.

❑ Jack and proper load rated jackstands

❑ 18mm and 21mm combination wrenches

❑ 18mm and 21mm 1/2” drive sockets and ratchets

❑ Large screw driver

1.

Raise vehicle and support with jackstands on a stable surface.

Note: Vehicle must be supported with vehicle’s normal weight on rear axle.

2.

Remove the right lower sway bar end link nut.

3.

Unclip the cable attached to stock panhard rod, remove bolts at each end and remove the stock panhard rod from

vehicle.

4.

With zerk fitting pointing down, install the Edelbrock panhard rod in the stock position. Note: Edelbrock panhard

rod is greased during assembly, but we recommend you grease them after installation and during normal service.

5.

After you have greased the bushing through the zerk fittings, torque panhard rod bolts 85 to 90 ft. lbs.

6.

Re-install sway bar end link and nut. Torque to 40 ft. lbs.

7.

Use supplied stainless steel hose clamps to retain the brake cable to the Edelbrock panhard rod. Unscrew the

clamp completely. Wrap it around the panhard rod and the metal sections of the cable, re-engage the clamp and

snug clamp. Do not overtighten!

Qty.

Part #

Description

1

25-4063

Panhard Rod Assembly