Autostart as-1252v User Manual

P. 8 

User Guide 

Diagnostics – Parking Light Flash Table 

•  Doors locked, starter kill armed 

•  Run time has expired 

•   

Ι 

ΙΙ

 buttons pressed 

•  Start signal received by the module 

•  Cold weather mode cancelled 

•  Reset from manual to automatic 

 

•  Doors unlocked, starter kill disarmed 

•  Remote start attempt cancelled by     

remote 

•  Exiting ignition valet 

•  Power-up reset 

•  Board set from manual to automatic; power 

ON 

•  Power ON to OFF (automatic transmission). 

 

•  Entering and exiting ready mode. 

•  Entering ignition valet 

•  +12 V detected on the brake input wire either while cranking or during run time 

•  Entering multi-speed tach programming 

•  Board set from automatic to manual; power ON 

•  Power ON to OFF (manual transmission) 

•  Tach signal programmed 

•  New transmitter programmed 

•  A remote start was attempted while a tach-before-crank signal was detected before cranking 

•  Unit reset  

•  A ground (-) signal was detected on the hood pin input wire  when attempting to remote start or 

during run time 

ΙΙ

•  The parking brake is connected to ground (automatic transmission) 

•  There was a remote start attempt while the vehicle was in valet mode 

•  Failed start: vehicle’s low battery voltage 

…followed by 1 flash 

Exiting cold weather mode 

…followed by 3 flashes 

Entering cold weather mode 

•  Idle mode: Idle mode is engaged 

•  Run time: The vehicle has been remote started and is in run time 

• The hood has been opened and a ground (-) signal has been detected on the hood pin input wire 

•  Locking or unlocking a door (with door pulses configured to 4 sec.) 

•  The hood pin has been flashed and you  now have access to the programming options 

•  Panic mode is triggered