Alliance Laundry Systems Stacked Drying Tumbler User Manual

Page of 38
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
31
M412060
Operating Instructions
The following steps outline the procedure for 
operating the tumbler through a complete drying 
cycle.
IMPORTANT: DO NOT TUMBLE fiberglass 
curtains and draperies unless the label says it can 
be done. If they are dried, wipe out the cylinder 
with a damp cloth to remove particles of fiberglass.
Always follow the fabric care instructions supplied by 
the garment manufacturer.
NOTE: Electrical power to the tumbler must be on. 
The AVAILABLE light will be lit. Refer to Figure 
14
.
1. Energize the electrical circuit to the tumbler at 
the disconnect switch or the circuit breaker.
2. Open the lint drawer and check for any 
accumulated lint on lint screen. Close drawer 
tightly against tumbler front panel and lock 
drawer securely.
IMPORTANT: Failure to tightly close lint drawer 
will result in the tumbler not starting.
3. Open the loading door and load the cylinder with 
laundry. The unit is designed for a 30 pound 
cotton load (dry maximum load). DO NOT 
overload! Overloading will result in excessive 
drying time, wrinkled laundry and wear to 
cylinder bearings or rollers.
4. Refer to Section IV of the Electronic Control 
manual for further instructions on how to operate 
the stacked tumbler. The Electronic Control 
manual is supplied with the tumbler.
To reduce the risk of fire: 
• DO NOT DRY articles containing foam 
rubber or similarly textured rubberlike 
materials.
• DO NOT DRY plastics, anything 
containing wax or chemicals such as 
mops and cleaning cloths, or anything 
dry-cleaned at home with a dry-cleaning 
solvent.
• DO NOT TUMBLE fiberglass curtains and 
draperies unless the label says it can be 
done. If they are dried, wipe out the 
cylinder with a damp cloth to remove 
particles of fiberglass.
W076
WARNING
To reduce the risk of serious injury, allow 
cylinder to stop before cleaning lint screen.
W412
WARNING