Alliance Laundry Systems Stacked Drying Tumbler User Manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

35

M412060

1. Remove belt guard cover.

2. Clean the lint and any other foreign materials 

from the air vents located on the front and back 
of the drive motor. The drive motor is air cooled 
and if the air vents become clogged, the motor 
will overheat and the internal thermal overload 
protector will cycle off.

3. Reinstall belt guard cover.

1. Remove front panel by removing lint drawer and 

loading door. Remove fastening screws for front 
panel, disconnect control housing, terminal 
blocks.

2. Pull front panel out. Remove any lint that has 

accumulated in the corner of the inside. Use a 
vacuum where possible or a small brush.

3. The poly-v cylinder belt tension is automatically 

set by a spring loaded idler system. There is no 
adjustment. The belt should show no signs of 
excess wear or cracking. If it does, replace with a 
genuine service replacement.

4. Inspect the belt tensioning idler assembly. The 

idler arm should move freely (with considerable 
belt-spring tension [approximately 40 pounds]) 
and should not bind in any position between 
stops.

5. Clean lint off any of the idler assembly parts.

6. Reassemble the front panel by lifting and placing 

the panel at its edge resting on the machine front.

7. Reach in through door opening, and connect the 

terminal blocks to each control housing.

8. Push the front panel into place and line up holes.

9. Insert corner screws first and then remaining 

screws. Tighten all screws.

10. Reinstall lint drawer, pressing it firmly against 

the front panel and locking it.

11. Reinstall loading door.

Check the tumbler over thoroughly for loose nuts, 
bolts and screws and for loose gas and electrical 
connections.

W657

W658