Auto Page car-pro cpx-rs2 User Manual

August, 2005 

RS-2 USA 

3

This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful 
for  occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the engine 
running and the climate control on. 

1.Before turning off the engine, Place the vehicle in “Park”; take your foot off the brake pedal; press the transmitter

 

button twice and the LED indicator will flash 3 times to confirm enter. 

2. Turn the ignition key to the “OFF” position and remove the key. (The engine will stay running.) 
3. The engine will run until the pre-programmed time has elapsed or one of the shutdown inputs is received. 

This unit can be programmed to start and run the engine every 3 hours. The engine will run for the programmed run time 
and then shut down. 
IMPORTANT: Timer Start should be used only in open areas. You should never start and run the vehicle in on enclosed 
space as a garage or carport. 
3 hours timer start: This feature is design for an extreme cold climate usage. The system will auto start the vehicle 
every 3 hours, to prevent extremely difficult cold start problems. A MAXIMUM OF SIX CYCLES CAN OCCUR.   
 
ENTER: 

1.  Press the transmitter 

 button twice to remote start the vehicle. As soon as the vehicle is running and the parking 

lights have turned on or flashing. 

2.  Immediately depress the 

  and 

 button together at the same time, within 2 seconds 

3.  Quickly press the 

 button. The parking light will flash (3) times. The horn (if installed) chirps (3) times. The vehicle 

is now programmed to start every (3) hours. 

4.  Press the brake pedal to stop the vehicle running. 
Exit the timer start: 
Timer start can be exited manually as follows: 
1.  Make sure the remote start system is not operating the engine. 
2. Turn the ignition “ON”. The parking light will flash (4) times. The horn (if installed) chirps (4) times.   
Or 

1. Press the transmitter 

 button twice to remote start the vehicle. As soon as the vehicle is running and the 

parking lights have turned on or flashing. 

2. Immediately depress the 

  and 

 button together at the same time; then press and hold 

 

button for 2 seconds. 

The parking lights will flash (4) times. The horn (if installed) will chirp (4) times. The vehicle is no longer programmed 
to start automatically. 

If any of the following conditions exist while the system is operating, the engine will not start or will shut down 
immediately: 
 
1. 

The hood is opened. 

2. 

The brake pedal is pressed. 

3. 

Move the optional remote start enable toggle switch to OFF position. (If installed) 

4. 

Engine is over-revved. {“Tachometer checking type” only} 

5. 

The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed. 

6. 

Press the transmitter 

 button. 

7. 

The vehicle refused to start running after {3} unsuccessful attempts. 

8. 

If your remote start does not start the vehicle after 3 attempts, please take your vehicle  back to your installing   

dealer for troubleshooting. 

 (If installed)

This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote 
started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the 
remote start, move the (optional) remote start enable toggle switch to the OFF position.