Edelbrock 5056 User Manual

Catalog #5056
Rev. 7/05 - RS/mc

Brochure #63-0423

Page 1 of 2

TORKER II INTAKE MANIFOLD

For 1965-1979 326-455 c.i.d. Pontiac V8

(Not for Ram-Air V Cylinder Heads)

Catalog #5056

INSTALLATION INSTRUCTIONS

PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools
and procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing
this installation, it is recommended to have the installation completed by a mechanic. If you have any questions, please call our

Technical

Hotline at: 1-800-416-8628, 7:00 am - 5:00 pm, Pacific Standard Time, Monday through Friday or e-mail us at
edelbrock@edelbrock.com.. PLEASE complete and mail your warranty card. Be sure to write the model number of this product in the
"Part #____" space.

THANK YOU.

•

DESCRIPTION:

The Torker II intake manifold is designed for 1965 to 1979 326-455 c.i.d. Pontiac V8 engines. It is a single plane design utilizing modern
air flow technology. It provides good low rpm response plus increased performance above the 5000 rpm range. Will not fit Ram-Air V
cylinder heads. Will not fit 265/301 V8s, or under Trans Am Shaker hood. Please note “Brackets” section below for your particular
installation.

•

EGR SYSTEMS: Intake manifold will not accept stock EGR (Exhaust Gas Recirculation) equipment. EGR systems are used on most
1972 and later model vehicles. Check local laws for requirements.

•

ACCESSORIES & INSTALLATION ITEMS: Major recommendations are listed below. See our catalog for details. To order a catalog,
call (800) FUN-TEAM, or visit www.edelbrock.com.

•

CARBURETOR RECOMMENDATIONS:

•

BRACKETS: The throttle and kickdown bracket on some vehicles may require modification to fit. For 1972 and later vehicles, use the
supplied #8014 bracket. For 1968-1971, use #8015 throttle bracket.

•

GASKETS: Do not use competition style intake gaskets for this street manifold. Due to material deterioration over time, internal
leakage of vacuum, oil, and coolant may occur.

A - Carburetor will work with non-EGR or pre-emission control systems.

I - Carburetor has no provisions for evaporative canister.

K - Carburetor requires #8008 or #8024 stud, washer and nut kit. Determine proper length based on gasket thickness and your accessory

mounting requirements.

N - Carburetor accepts factory cruise control

O - Carburetor comes with manual choke. It can be converted to electric choke using kit #1478.

INTAKE MANIFOLD

REFERENCE

RECOMMENDED GASKET

5056

(None)

Edelbrock #7280 Port: 1.18” x 2.20”, .060” Thickness

NOTE: To ensure maximum performance and a proper seal, Edelbrock gaskets which

are specifically designed and manufactured for use with Edelbrock parts must be used.

CARBURETOR

REFERENCE

PARTS REQUIRED FOR INSTALLATION

Performer #1407 (750 cfm)

A, I, K, N, O