Edelbrock r09392s User Manual

©2006 Edelbrock Corporation
Brochure No. 63-R09392S

Catalog #R09392S

Rev. 7/06 - BC/mc

Please study these instructions carefully before installing your new Brake Hose Kit. If you have any questions, please call
our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday - Friday, Pacific Standard Time or e-mail us
at Edelbrock@Edelbrock.com.

IIMPORTANT NOTE: Do not allow the master cylinder to completely drain of brake fluid at any time during this process.

Also, use care when handling brake fluid, as it can quickly damage finished surfaces (paint, plating, etc.).

1.

Remove factory rear brake hose, noting routing.

2.

Install bent banjo hose end onto master cylinder so hose loops upward, similar to factory.

3.

Install straight hose end onto caliper oriented approximately 30° inward 

4.

Use supplied cushion clamp to secure hose at factory location on swingarm.

5.

Check hose clearance throughout entire suspension travel range.

6.

Bleed system and check for leaks while applying pressure.