honda-automobiles mm60 User Manual

Install with the tractor on level ground. 
Lock the parking brake, set the transmission lever 
in "N" (Neutral) and the PTO clutch lever in the 
"OFF" position. Set Lift Control lever to "DOWN" 
and turn Lowering Speed Control knob fully 
counter-clockwise 

("FAST"). This allows you to pull 

the rear lift arms down by hand and makes assem- 

bly easier. 

1.

2.

Remove drawbar assembly; this is bolted onto 

the transmission housing below the Rear PTO. 

Retain bolts, nuts and spacers for installation of 
lift plate assembly. Remove any dirt and debris 

from bottom of transmission housing and make 
sure bolt holes and screw threads are clean. 

Assemble 

Y-lift bracket to

 lift plate assembly. 

Raised flange on 

lift plate assembly will face rear 

of tractor. Insert 

Y-lift bracket so that fork

 of Y  

faces front of tractor. 

3. 

Attach mower 

lift plate assembly to tractor, 

passing the two projecting stud bolts on the 

transmission housing through the holes in the lift 

plate flange. Slide on 

2 spacers previously 

removed and hand tighten both 

26 mm flange 

locknuts. 

4.

Reach beneath the mower 

lift plate assembly 

and carefully insert the four 

12 mm x 32 mm 

bolts through holes in lift plate assembly and 
into threaded holes on bottom of transmission 
housing. Housing 

is 

made of aluminum, 

so start 

bolts by hand to guard against cross threading. 

Tighten to 7 kg-m 

(50 

ft-lb). 

5. 

Finish by tightening two 

26 mm flange locknuts 

on projecting studs to 

7 

kg-m 

(50 

ft-lb). 

Wear heavy gloves to protect 

your hands when installing lift link kit and 
mower deck. 

Lifting system can crush fingers 

and hands, 

so keep them clear of links and 

lift 

arms when operating.