honda-automobiles mm60 User Manual

< 

\ 

Installing and Adjusting Wheels 
1. 

Pull release pin on wheel yoke 

so 

that wheel 

arm can be raised 

to 

insert wheel. Assemble 

wheel by inserting 1/2 

x 5 in. sleeve through 

wheel. Place 1/2 in. washer on 1/2 

x 5 in. bolt 

and insert though yoke and sleeve in wheel. 
Secure with flanged locknut. Tighten locknut so 

that sides of bracket touch wheel sleeve without 

binding. 

Do 

not over-tighten. Repeat for other 

front caster wheel. 

2. Assemble the rear gauge wheels so that grease 

fittings are to the inside for lubrication access. 

Raise rear of mower deck with lever or jack an

d 

insert wood block beneath mower deck to 
support it while installing wheels. Insert sleeve 

through wheel. Place washer on bolt and insert 
through sleeve in wheel and rear gauge wheel 

arm. Secure with flanged locknut. Tighten 
locknut 

so that sides of bracket touch wheel 

sleeve without binding. 

Do not over-tighten. 

Repeat for opposite side. 

3. 

Raise front and rear wheels to middle position, 

insert pin in center hole of adjustment bracket. 
Cutting height 

will be 2.75 in. Level the mower to

assure proper cut. Mower also needs slight 
forward tilt. 

If adjusting wheels and blade height 

after installing mower on tractor, make sure 
engine 

is off and key 

is removed before 

looking under mower. 

Leveling the Mower 
Level 

the mower to assure proper cut. Mower 

needs slight 

(3/8 in) forward tilt. If you are adjust- 

ing wheels and blade height after installing mower 
on tractor, make sure engine is off and key re- 
moved before looking under mower. 

NOTE: 

Before measuring blade height, turn mower 

blades 

so that the right and left blades point 

towards front of mower.