honda-automobiles mm60 User Manual

1. Remove right and left pulley covers (as viewed 

from rear of mower). Right cover is held on by 
two 

bolts and one nut, left cover by two bolts. 

Retain bolts and nuts to replace cover. 

2. Grasp belt with both hands on either side of the 

rear center idler pulley (see illustration for 
location). Pull back towards you to create 

enough slack to slip belt off pulley. 

3. 

Belt will now 

be quite slack and can easily be 

removed from other pulleys, including tensioner 

arm pulley (illustrated). 

3. 

To remove belt from gearbox driven pulley, 

remove the two bolts holding front of the 
gearbox mount to mower deck, and loosen the 

two bolts on the rear of the gearbox mount. Tip 
the gearbox up and slip the belt 

off the gearbox 

pulley and slide it underneath the gearbox to 
completely remove. 

1. Remove the two bolts holding front of gearbox 

mount to mower deck, and loosen the two rear 
bolts (if not done previously). 

2. Tilt gearbox up and slide belt underneath 

gearbox. Fit into pulley V-grove and reinstall 
bolts. 

3. 

Fit belt over all except center rear idler pulley. 

Make sure that belt goes behind pivot 

on 

tensioner arm (belt makes a bend at this point). 

4. Grasp belt with both hands, and pull back 

towards you. Slip belt over center idler pulley. 

5. Reinstall left and right pulley covers. Do not 

operate without pulley covers installed.